What Size Drill Bit For 5/16 Concrete Anchor. Web match the bit to the size screw you’re using: For both the molly and plastic drywall anchor, the suggested drill bit size will be 1/2″ and, still, if you fail to determine the accurate size of the drill bit for your drywall anchor, here is a handy chart for your quick identification:
Zinc plated / carbon steel. When drilling masonry holes in concrete, the hole should be 1/4 inch larger than the fastener’s diameter. These bits allow you to easily switch to another size by changing only the bit body. The hole must be drilled with a 5/8 ” carbide tipped bit drill bit that meets ansi standards and used in a hammer drill that is. Olin wade (remodel or move stuff) for a 5/16 concrete anchor, you should drill a 7/16 inch hole. Web the 3/16” tapcon uses a 5/32” bit, the 1/4” tapcon needs a 3/16” diameter bit, the 3/8” tapcon requires a 5/16”, the 1/2” tapcon requires a 7/16” bit, a 5/8”tapcon needs a 1/2” bit and the 3/4” tapcon requires the use of a 5/8” carbide tipped bit. Size (in.) drill bit dia. Web how tap sizing works for 5/16″ tap. To tap a 3/16” tapcon, use a 5/32” bit, 1/4” tapcon, 3/8” tapcon, 1/2” tapcon, and 3/4” tapcon, use 3/16” diameter bits, Web the standard drill bit is universally used for drilling smaller pilot holes in concrete, block and brick, and works seamlessly with tapcon anchors.
Deeper embedments will yield higher tension and shear capacity. Web if your anchor type is a toggle bolt, choose the drill bit size at 5/16″ drill bit. Web normally drill bit size is equal to the anchor diameter for the concrete anchors. Reference should be made to applicable codes for the specific working ratio. To determine screw length, add the anchor length to the fixture thickness and choose a screw longer than this. Web what is the best size drill bit to use for a 5/16 inch concrete anchor? Web the diameter of the hole that needs to be drilled into the concrete for the 5/8” x 10” red head trubolt wedge anchor is 5/8”. Deeper embedments will yield higher tension and shear capacity. Web cut tubing to the length needed for the application, mark tubing as noted below and attach other end of tubing to the mixing nozzle. To tap a 3/16” tapcon, use a 5/32” bit, 1/4” tapcon, 3/8” tapcon, 1/2” tapcon, and 3/4” tapcon, use 3/16” diameter bits, For a 5/16″ tap, either an 18 or 24 inch, the diameter.
